Panasonic FP-E - Page 27

1.1 Table of Relays, Memory Areas and Constants
1-3
FunctionNumberingItem Function
T32CC32/SL1C10/C14
/C16
Item
Constant Decimal
tt
(K)
K−32768 to K32767 (for 16-bit operation)
constants
()
K−2147483648 to K2147483647 (for 32-bit operation)
Hexadecimal
tt
(H)
H0 to HFFFF (for 16-bit operation)
constants
()
H0 to HFFFFFFFF (for 32-bit operation)
Floating point
tpe
(F)
F−1.175494×10
−38
to F−3.402823×10
38
g
p
type
()
F1.175494×10
−38
to F3.402823×10
38
Notes
1) The points for the timer and counter can be changed by the
setting of system register 5. The numbers given in the table
are the numbers when system register 5 is at its default
setting.
2) There are two unit types, the hold type that saves the
conditions that exist just before turning the power off or
changing form the RUN mode to PROG. mode, and the
non−hold type that resets them. For the FP0 T32C, the
selection of hold type and non−hold type can be changed by
the setting of system register. These areas can be spcified as
hold type or non−hold type by setting system register. For the
FP0 C10/C14/C16/C32/SL1, that area is fixed and allotted the
numbers as shown below.
Hold type and Non-hold type areas
Item C10/C14/C16 C32/SL1
Timer Non−hold type: All points
Counter
Non-hold type From the set value to C139 From the set value to C127
Hold type 4 points (elapsed values)
(C140 to C143)
16 points (elapsed values)
C128 to C143
Internal
relay
Non-hold type 976 points
(R0 to R60F)
61 words
(WR0 to WR60)
880 points
(R0 to R54F)
55 words
(WR0 to WR54)
Hold type 32 points (R610 to R62F)
2 words (WR61 to WR62)
128 points (R550 to R62F)
8 words (WR55 to WR62)
Data
register
Non-hold type 1652 words
(DT0 to DT1651)
6112 words
(DT0 to DT6111)
eg s e
Hold type 8 words
(DT1652 to DT1659)
32 words
(DT6112 to DT6143)
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com