High−level Instructions
3 − 489
Data table settings
S Control code (*1)
S+1 Frequency (Hz) K40 to K10000 (Hz) (*2)
(*1): Specify the control code by setting the constant H.
Operation mode and directional output
00: No counting mode
10: Incremental counting mode with no directional output
12: Incremental counting mode with directional output off
13: Incremental counting mode with directional output on
20: Decremental counting mode with no directional output
22: Decremental counting mode with directional output on
23: Decremental counting mode with directional output off
H □□□
Pulse width specification
0: Fixed pulse width (approx. 80µs)
(CPU ver. 2.1 or later)
1 to 9: Duty ration approx. 10 to 90% (10% increments)
(*2): When the pulse width is set to duty 50%, the maximum is 6kHz. When the pulse width is set to
fixed pulse width (approx. 80µs), the maximum is 9.5kHz.
(Thermocouple input type of FP−e is removed.)
Notes for using FP0 compatiblity mode of FP0R
1
The elapsed value and target value of high−speed counter and pulse
output is signed 32−bit values.
2
The high−speed counter continues counting even if data exceeds the FP0
range (signed 24−bit).
3
The pulse output continues outputting even if data exceeds the FP0 range
(signed 24−bit).
4
The waveforms of pulse output are a duty cycle of 25% regardless of the
designation of instructions.
5
Even if the no count setting is specified with a pulse output instruction, it
counts in the addition mode.
6
The maximum frequency of pulse output is 10000Hz.
7
When using the pulse output instruction, it is not used for the pulse ouput
and normal output.
Supplement to the operation in the case with the direction output
1: FP0
1: When specifying a duty of 50%: The pulse output will start approx. “Initial
speed period/2” hours later after the direction output.
When the initial speed is 500Hz, it is approx. 1ms.
2: When specifying 80us fixedly: The pulse output will start approx. “Initial
speed period − 25us” hours later after the direction output.
When the initial speed is 500Hz, it is approx. 1.98ms.
FP0/FP−e
To Next Page