6.5.6 Changing Communication Mode Using F159(MTRN) Instruction
An F159 (MTRN) instruction can be executed to change between general-purpose serial communication
mode and computer link mode. To do so, specify H8000 for n (the number of transmission bytes) and
execute the instruction.
Changing from “general-purpose” to “computer link”
Changing from “computer link” to “general-purpose”
R9032: The COM port mode flag turns on when general-purpose serial communication mode is selected.
Note:
When the power is turned on, the operating mode selected in system register 412 takes effect.
It is not possible to change to the MODBUS RTU mode.
To Next Page
Loading...
