Terminal screwdriver
Necessary when wiring relay output type & terminals (Phoenix).
Attachment example
Wiring tools Parts for attachment I/O cables & networks
Order number
: AFP0806
Slim attachment plate model
Screw-stop attachment plate. Slim model.
Order number
: AFP0803 (set of 10)
Attachment example
DIN rail attachment
example
Flat attachment plate model
Screw-stop attachment plate. Flat model.
<Length 1m > 2 cable set
<Length 3m > 2 cable set
Transistor output type I/O cable
Loose-wiring cable (10 leads) AWG24 with connectors
attached at one end, 1 set: 2 cables
Order number
: AFP0804 (set of 10)
Input simulator
for FP0 relay output type, 6 switches
Order number
: SWITCH-FP0
Loose-wiring connector pressure contact tool
Necessary when wiring transistor output type connectors.
Order number
: AXY52000
Order number
:
AT8DLA1
C-NET adapter S2 type
Adapter for linking to a higher-placed computer.
With 30cm dedicated cable. Power source unnecessary.
Order number
: AFP15402
DIN rail
Standard DIN rail of width 35mm 1.378inch
and length 1m.
Order
number:
Stopper fitting
DIN rail stopper fitting.
ATA4806
Order
number:
AFP0521
Order
number:
AFP0523
Accessories
Products and order numbers
Notes:
(1) One I/O cable set (2 cables) is necessary with the following models: FP0-C10RS, C14RS, E8RS, E16RS.
(2) One I/O cable set (2 cables) is necessary with the following models: FP0-C16T/C16P, E16T/E16P.
(3) Two I/O cable sets (total 4 cables) are necessary with the following models: FP0-C32T/C32P, E32T/E32P.
Terminal socket
Attaches to relay output terminal type.
Additional part.
Order number
: AFP0802
2 sockets
per pack
()
Loose-wiring pressure socket
Transistor output type connectors.
Additional part.
Order number
: AFP0807
2 sockets
per pack
()
Power cable
Attaches to control units and relay output
type expansion units. Length: 1m.
Order number
: AFP0581
1 cable
per pack
()
To Next Page
Loading...
Need help?
General
