Panasonic FV-30BW2H - Heating, Drying, and Ventilation Modes

In the heating mode running for 30 seconds above, press the
button to stop the heater. The fan will stop running after a delay
of 10 seconds.
Heater may stop heating when temperature in bathroom is up to required degree,
and may restart heating as the temperature in bathroom cools down.
2.
1.
Hot startup function: After the product starts up in the strong heating mode when the
temperature in the bathroom is lower than 20 °C, it enters the hot startup status to
avoid blowing of cold air, and the fan runs at a low speed. When the temperature in
the bathroom reaches 20 °C or above or after running for 60 seconds, the hot startup
status stops and the fan runs at a high speed.
1
2
3
5
在沐浴前開暖氣功能，可提前把浴室加溫。
按 按鈕，暖氣模式以強檔開始運轉，再按一次將切換為弱檔。
運轉過程中，可通過 調整設置時間。
運轉過程中，可通過 按鈕，調整上下風向。
當浴室內溫度上升到一定程度時，加熱器停止工作，待溫度下降到一定程度後，加熱器重新開始
工作。
運轉完所設置時間後，本機會自動停止。
如需在運轉途中停止，請按 按鈕。
熱啟動功能：當浴室溫度低於20 °C時，以暖氣強檔模式啟動後，為避免冷風吹出，產品進入熱
啟動狀態，扇葉以低速運轉，待浴室溫度達至20 °C以上或經過60秒 後 ， 熱 啟 動 狀 態 停 止 ， 扇 葉
以高速運轉。
若在暖氣模式運轉30秒以上，按 按鈕後，為使加熱器冷卻，
扇葉將延遲10秒停止運轉。
Before taking a bath, start the heating function to warm the
bathroom beforehand.
Press the button to start the heating mode at the HI.
It will switch to the LO. mode if you press this button again.
During running, you can press to change the set time.
This product will stop automatically when the set time is up.
To stop midway in running,pressthe button.
During operation, you can press the button to adjust up and
down air direction.
18
暖氣功能的使用方法
HOW TO USE HEATING FUNCTION
4
(Initial settings)
(初始 設置)
強
HI
弱
LO
Use when you feel cold in a bath
在沐浴中感到冷時使用