Sound
No sound.
Press / to cancelmute.
Turn off the concealed mode. ( Concealed Mode)
Restart the computer.
Beeping sounds are not emitted by thisdevice.
Distorted sound.
Stop and restart playback.
Cannot record with microphone
Use a monauralcondenser microphone.
Cannot change the volume by pressing
/
.
Activate the Windows sound function. When it is not active, the volume does not change even if
slide bar isdisplayed.
The microphone volume is small.
Increase the volume of the microphone according to the following steps.:
1.
Touch (Start) - [Windows System] - [Control Panel].
2. Touch [Hardware and Sound] - [Sound] - [Recording] - [Microphone Array] - [Prop-
erties], and then increase the volume of [Microphone Array] and/or [Microphone
Boost] in [Levels].
When signing in (e.g., resuming the com-
puter), audio is distorted.
Perform the following steps to change the audio settings to prevent audio output.
1.
Touch and hold (Speaker) on the tasktray, and touch [Sounds].
2. Remove the checkmark from [Play Windows Startup sound].
The feedback noise may occur.
To stop microphone's monitoring output.
1.
Touch (Start) - [Windows System] - [Control Panel].
2. Touch [Hardware and Sound] - [Sound] - [Recording] - [Microphone Array] - [Prop-
erties], and then remove a check mark for [Listen to this device] in [Listen].
Input Characters
Cannot enter specialcharacters (ß, à, ç,
etc.) and symbols.
Use the character map.
1.
Touch (Start) - [Windows Accessories] - [Character Map].
2. Input “Character”.
Network
<Only for modelwith LAN>
Cannot connect to a network.
Set the device [Extension Port] to [Enabled] in the [Advanced] menu of the Setup Utility.
<Only when using the Cradle with LAN>
Cannot connect to a network.
Set [Cradle USB Port] to [Enabled] in the [Advanced] menu of the Setup Utility.
- 113 -
To Next Page
Loading...
