Panasonic HC-X2 - Page 246

Screen status display – Screen display during shooting
246
5 Recording status
Displays the recording status of the memory card in card slot 1 or card slot 2.
, :
Not target for recording.
(flashing), (flashing):
Recognizing the memory card.
, :
The recording is stopped while the recording target memory card is inserted.
, :
Recording.
(Flashing red dot), (Flashing red dot):
Processing to stop the recording.
[P ], [P ]:
Recording is stopped with pre-recording is enabled and the recording target memory card is inserted.
(No display):
It is in one of the following conditions.
– A memory card has not been inserted.
– The memory card cannot be recognized.
• The following indicators are displayed in card slot 1 only.
[P]:
Pre-recording is enabled, and the memory card is not inserted in the card slot, or the memory card is not recognized.
:
The tally lamps are instructed to illuminate in red via network.
:
The tally lamps are instructed to illuminate in green via network while the recording is stopped.
The tally lamps do not illuminate green.
6 Remaining recording capacity and status of the memory card
Displays the remaining recording capacity and status of the memory card in card slot 1 or card slot 2.
[0min] to [999min]:
Remaining recording capacity (999 minutes or more is displayed as [999min])
– The display will flash when the remaining recording capacity becomes 2 minutes or less.
– The recording capacity available for simultaneous recording (recording capacity for the memory card of the 2 memory
cards with less recording capacity) is displayed when simultaneous recording is performed.
[WP]:
Write protected (the write protection switch of the memory card is set to the LOCK side)
[END]:
No remaining recording capacity (no remaining recording capacity on the memory card)
[ERR]:
A memory card that cannot record is inserted (the card is recognized but cannot record due to a format error, a card other
than a memory card being inserted, etc.)
[!SDXC]:
An SDXC memory card is not inserted in MOV recording/MP4 recording
(No display):
It is in one of the following conditions.
– A memory card has not been inserted.
– The memory card cannot be recognized.