Chapter 4 Operation — Menu settings
- 65 -
[CAMERA] menu
Sets the basic functions of the camera.
This menu cannot be set when the thumbnail screen is displayed.
[SW MODE]
[ZOOM RING]
Sets the rear ring 1 direction and zoom control when performing zoom operations.
(Factory setting: [DOWN TELE])
[IRIS RING]
Sets the rear ring 1 direction and iris control when adjusting the iris.
(Factory setting: [DOWN OPEN])
[SUPER GAIN]
Sets the super gain to be assigned to the USER button.
When [ALL] is selected, each time you either press the USER button or touch the USER button icon, the selection switches in the order [SUPER GAIN],
[SUPER GAIN+], normal gain.
The items that can be set are as follows.
≥ [SUPER GAIN], [SUPER GAIN+], [ALL]
(Factory setting: [SUPER GAIN])
[AGC LIMIT]
Sets the maximum gain value during [AGC] operation.
The items that can be set are as follows.
≥ [3dB], [6dB], [12dB], [18dB], [24dB], [30dB]
(Factory setting: [30dB])
[O.I.S.]
Switches enable/disable of the optical image stabilizer function.
If [O.I.S.] is assigned to the USER button, pressing the USER button switches [ON]/[OFF].
For details about optical image stabilizer, refer to “Optical image stabilizer function”. (l 138)
(Factory setting: [ON])
[HYBRID O.I.S.]
Switches enable/disable of the hybrid optical image stabilizer function.
For details about optical image stabilizer, refer to “Optical image stabilizer function”. (l 138)
(Factory setting: [ON])
[O.I.S. MODE]
Switches the operation mode of the optical image stabilizer function.
(Factory setting: [NORMAL])
[DOWN TELE] Zooms in when turned towards the B side.
[UP TELE] Zooms in when turned towards the A side.
[DOWN OPEN] Iris opens when turned towards the B side.
[UP OPEN] Iris opens when turned towards the A side.
[ON] Enables the optical image stabilizer function.
[OFF] Disables the optical image stabilizer function.
[ON] Enables the hybrid optical image stabilizer function.
[OFF] Disables the hybrid optical image stabilizer function.
[NORMAL] Specifies the standard setting for a good balance of correction for large and small camera shake.
[PAN/TILT] Specifies a setting appropriate for shooting that uses a lot of panning and tilting of the camera.
[STABLE] Specifies a setting appropriate for fixing a composition to shoot a subject.
A
B
A
B
To Next Page
Loading...
