Panasonic HC-X2000 - Page 81

Chapter 4 Operation — Menu settings
- 81 -
[D.ZOOM]
Switches display/hide of digital zoom ratio.
The items that can be set are as follows.
≥ [ON], [OFF]
(Factory setting: [ON])
[IR REC]
Switches display/hide of the settings in the [CAMERA] menu → [SW MODE] → [IR REC].
The items that can be set are as follows.
≥ [ON], [OFF]
(Factory setting: [ON])
[PLAYBACK STATUS]
Switches display/hide of the playback status.
The items that can be set are as follows.
≥ [ON], [OFF]
(Factory setting: [ON])
[MARKER]
[CENTER MARKER]
Switches the type of center marker.
(Factory setting: [1])
[SAFETY MARKER]
Selects the type of frame for the safety zone marker.
(Factory setting: [2])
[FRAME MARKER]
Sets the aspect ratio of the frame marker. The frame marker is not displayed when [OFF] is selected.
The items that can be set are as follows.
≥ [4:3], [13:9], [14:9], [1.85:1], [2.35:1], [OFF]
(Factory setting: [OFF])
[FOCUS ASSIST]
[FOCUS ASSIST SW]
Sets how focus assist is set when the [FOCUS ASSIST] in the USER button is set.
(Factory setting: [EXPAND&PEAKING])
[EXPAND MODE]
Sets the enlargement display function mode.
(Factory setting: [10SEC])
[EXPAND VALUE]
Adjusts the enlargement factor of the enlarged display function.
The items that can be set are as follows.
≥ [×2], [×3], [×4]
(Factory setting: [×2])
[1] i (large)
[2] Open center (large)
[3] i (small)
[4] Open center (small)
[OFF] Does not display.
[1] Box
[2] Corners
[OFF] Does not display.
[EXPAND] Sets the enlarged display.
[PEAKING] Sets the peaking display.
[EXPAND&PEAKING] Sets both [EXPAND] and [PEAKING].
[10SEC] Disables the enlarged display function after 10 seconds have elapsed.
[HOLD] Enables the enlarged display function until either the USER button assigned to [FOCUS ASSIST] is pressed again or the
USER button icon is touched again.
[UNTIL REC] Enables the enlarged display function until performing recording operation.