Chapter 4 Operation — Menu settings
- 84 -
[REC FUNCTION]
[REC MODE]
Selects the recording mode.
(Factory setting: [NORMAL])
[INTERVAL TIME]
Sets the interval duration for interval recording.
The items that can be set are as follows.
≥ [1s], [2s], [5s], [10s], [30s], [1min], [5min], [10min]
(Factory setting: [5min])
[TC/UB]
[TC PRESET]
Sets the default value of the time code to record.
(Factory setting: [00]) (each item)
≥ “h” is an abbreviation for hour, “m” for minute, “s” for second and “f” for frame.
[UB PRESET]
Sets user bits.
Enabled only when [USER] is selected in [UB MODE] of [TC/UB].
Each digit can be set in following range.
≥ [00]…[FF]
(Factory setting: [00])
[FREE/REC RUN]
Sets how the time code generator advances.
(Factory setting: [REC RUN])
0 The setting is fixed to [REC RUN] when the [SYSTEM] menu → [SUPER SLOW] → [ON] is set.
0 The setting is fixed to [FREE RUN] when the [RECORDING] menu → [PRE REC] → [ON] is set.
0 The setting is fixed to [FREE RUN] when the [RECORDING] menu → [2 SLOTS FUNC.] → [BACKGR REC] is set.
0 The setting is fixed to [REC RUN] when the [RECORDING] menu → [REC FUNCTION] → [REC MODE] → [INTERVAL] is set.
[DF/NDF]
Sets the count method for the time code generator.
Enabled only when the frame rate of the [SYSTEM] menu → [REC FORMAT] is set to 59.94i/59.94p/29.97p.
(Factory setting: [DF])
0 The setting is fixed to [NDF] when the [RECORDING] menu → [REC FUNCTION] → [REC MODE] → [INTERVAL] is set.
[NORMAL] Performs the standard recording.
[INTERVAL] Performs the interval recording. (l 132)
Hour [00]…[23]
Minute [00]…[59]
Second [00]…[59]
Frame [00]…[23] (when [23.98p])
[00]…[24] (when [50.00i], [50.00p], or [25.00p] is set)
[00]…[29] (when [59.94i], [59.94p], or [29.97p] is set)
[FREE RUN] Advances regardless of the operation mode.
[REC RUN] Advances only while recording.
[DF] Uses the drop frame mode.
[NDF] Uses the non-drop frame mode.
To Next Page
Loading...
