Chapter 4 Operation — Menu settings
- 92 -
[UPDATE]
Updates the firmware.
Insert the memory card where the update file is saved into card slot 1.
The items that can be selected are as follows.
≥ [YES], [NO]
[ECO MODE]
By setting [OTHERS] menu → [ECO MODE] → [BATTERY]/[AC]/[NETWORK], when there is no button operation or LCD monitor touch operation
performed for a certain time, the power turns off automatically.
0 In the following cases, even if [BATTERY], [AC], or [NETWORK] is set to [ON], the power will not automatically turn off.
j While a memory card is being accessed (during recording, during playback, while formatting the media, etc.)
j During pre-recording
j In card reader mode
0 In the following case, even if [BATTERY] is set to [ON], the power will not automatically turn off.
j When using the AC adaptor
*
0 In the following cases, the power will not automatically turn off.
j When connected to a network via wireless LAN
* The power turns off automatically if the [AC] eco mode functions.
[BATTERY]
When about 5 minutes have passed without any operation, this unit automatically turns off to save battery life.
The items that can be selected are as follows.
≥ [ON], [OFF]
(Factory setting: [ON])
[AC]
If there are no operations for approximately 15 minutes while using the AC adaptor, the power turns off automatically.
The items that can be selected are as follows.
≥ [ON], [OFF]
(Factory setting: [ON])
[NETWORK]
If there are no operations for approximately 15 minutes when the [NETWORK] menu → [DEVICE SEL] → [WLAN] is set while not connected to the
network via a wireless LAN, the power turns off automatically.
The items that can be selected are as follows.
≥ [ON], [OFF]
(Factory setting: [ON])
[APPROVED REGULATION]
Display the authentication information for this unit.
≥ Select [`]/[{] and you can show the second page.
[LANGUAGE]
Sets the display language.
The items that can be selected are as follows.
(Factory setting: [English])
[MENU INITIALIZE]
Returns the setting value of the menu to the factory setting. The unit is restarted after executing.
[English] English
[Español] Spanish
[Français] French
To Next Page
Loading...
