Panasonic HDC-TM300 - Touch Screen Calibration; Changing the Picture Quality on the LCD Monitor; Viewfinder Adjustment

40
VQT1Z27
Perform the touch screen calibration if a different
object to the one touched is selected.
1 Select the menu. (l 31)
≥ Touch [ENTER].
2 Touch [r] with the supplied
stylus pen and enter in
calibration.
≥ Touch the [i] in the order it is displayed.
(5 locations)
3 Touch [ENTER].
≥ Calibration cannot be performed when the LCD
monitor is turned 180o.
≥ The Intelligent auto mode is set to off.
(l 45)
Select the menu. (l 31)
[DYNAMIC]:
The image on the LCD monitor becomes clear
and vivid. Optimum contrast and brightness are
set depending on the scenes recorded. Clear
and brilliant images are presented.
[NORMAL]:
Switches to the standard picture quality.
≥ When the [POWER LCD] is set to or ,
it is set to [DYNAMIC], or when the [POWER
LCD] is set to or , it is set to
[NORMAL], and the setting cannot be
changed.
∫ Adjusting the field of view
It adjusts the field of view to show the images on
the viewfinder clearly.
Adjust the focus by rotating the
eyepiece corrector dial.
≥ Extend the viewfinder and close the LCD
monitor to turn on the viewfinder.
Touch screen calibration
[SETUP] # [CALIBRATION] # [YES]
Changing the picture quality
on the LCD monitor
[SETUP] # [LCD AI] # [DYNAMIC] or
[NORMAL]
Viewfinder adjustment
+1
+2
- 1
A
HDC-TM300
HDC-HS300
HDCTM300&HS300EB-VQT1Z27_mst.book 40 ページ ２００９年１月２１日 水曜日 午後３時７分