41
VQT1Z27
∫ Adjusting the brightness of the
viewfinder
1 Extend the viewfinder and open
the LCD monitor.
2 Select the menu. (l 31)
≥ The viewfinder turns on.
3 Touch [BRIGHTNESS].
4 Touch / to adjust the
setting.
≥ After adjustments are made if no operations
are performed for about 2 seconds, the bar will
disappear.
5 Touch [ENTER].
≥ Touch [EXIT] or press the MENU button to
complete the setting.
¬Change the mode to or .
Extend the viewfinder and rotate the
LCD monitor towards the lens side.
≥ LCD monitor and viewfinder are turned on
during the face-to-face recording when the
viewfinder is extended.
≥ The image is horizontally flipped as if you see
a mirror image. (However the image recorded
is the same as a normal recording.)
≥ Record by viewing the image in the viewfinder
during the face-to-face recording.
≥ Only some indications will appear on the
screen. When ° appears, return the direction
of the LCD monitor to normal position and
check the warning/alarm indication. (l 138)
[SETUP] # [EVF SET] # [YES]
Recording showing the
contents to a partner
HDCTM300&HS300EB-VQT1Z27_mst.book 41 ページ ２００９年１月２１日 水曜日 午後３時７分
To Next Page
Loading...
