48
VQT1Z27
3 Open the LCD monitor or extend
the viewfinder.
The status indicator A lights red and the unit is
put into recording pause.
≥ Quick start standby mode is cancelled if
jabout 5 minutes elapsed
jmode is set to
junit is turned off
≥ Time for quick start will be more than
0.6 seconds slower when digital cinema is
used.
≥ Depending on the recording conditions, time
for quick start may be more than 0.6 seconds
slower in still picture recording mode.
≥ It may take some time for automatic white
balance to adjust.
≥ In the quick start mode, the zoom
magnification becomes 1k.
≥ If [ECONOMY] (l 34) is set to [5 MINUTES]
and the unit automatically goes into quick start
standby mode, close the LCD monitor and then
open it again.
≥ Quick start standby mode cannot be released
by the remote control. Turn the mode to OFF
when powering off.
(Only when recording to an SD card or
built-in memory)
The unit is put into recording pause approx.
1.9 seconds when the mode is set to or
from OFF.
≥ Start time will not shorten if there is no SD card
inserted.
Start time will be shorten if the [Built-in
Memory] is selected in the [MEDIA SELECT],
even if there is no SD card inserted.
¬Change the mode to or .
1
Select SD card as a media to
record from the menu. (l 31)
2 Select the menu. (l 31)
≥ This function’s default setting is [ON].
≥ Depending on the recording conditions, start
time may be longer than 1.9 seconds in still
picture recording mode.
≥ In the quick power on mode, the zoom
magnification becomes 1k.
Quick power on
[MEDIA SELECT] # [SD CARD]
[SETUP] # [QUICK POWER ON] # [ON]
HDCTM300&HS300EB-VQT1Z27_mst.book 48 ページ ２００９年１月２１日 水曜日 午後３時７分
To Next Page
Loading...
