Getting Started 15
4 Customising the Hybrid IP-PBX
System programming of the Hybrid IP-PBX can be performed using PC software. The software
for the KX-TDA15 is shared by both the KX-TDA15 and KX-TDA30, and is referred to as the
“KX-TDA30 Maintenance Console”. KX-TDA30 Maintenance Console’s Quick Setup lets you
easily configure the Hybrid IP-PBX to receive intercom and trunk calls, as well as apply basic
settings such as time and date.
Note
The contents and design of the software are subject to change without notice.
4.1 Connecting the PC
To programme the Hybrid IP-PBX, connect it to the PC with serial interface.
Serial Interface Connection
USB Port
RS-232C Port
PC
PC
To USB Port
To COM Port
RS-232C (Cross Cable)
Pin Assignments
Pin No.
2
3
4
5
6
7
8
Pin No.
2
3
4
5
6
7
8
COM PortRS-232C Port
To Next Page
Loading...
