Getting Started 17
1. Connect the PC to the Hybrid IP-PBX with a
USB cable.
2. Start the KX-TDA30 Maintenance Console
from the start menu.
3. a. Type the Installer Level Programmer
Code (default: 1234).
b. Click [OK].
4. Click "Connect" "USB" or "RS-232C" from
the menu bar, depending on the serial
interface connection with the Hybrid IP-PBX.
5. a. Type the system password for installer
(default: 1234).
b. Click [OK].
6. When country/area data do not match:
a. Click [OK] to replace the country/area data
of the Hybrid IP-PBX. Replacement may
take several minutes to complete.
b. Follow the procedure described in "3
Starting the Hybrid IP-PBX" and restart
the Hybrid IP-PBX.
c. Repeat steps 2 to 5 to restart the KX-
TDA30 Maintenance Console.
7. Follow the instructions of the wizard and
assign the basic items (Quick Setup).
To Next Page
Loading...
