1-5. SATA0
HDD 0 Type check.
1-6. SATA1
HDD 1 Type check.
2. Model No., Serial No. and UTR
PE Diag shows Model No., Serial No. and UTR (Used Time Record) automatically at startup of PE
Diag.
PE Diag reads the data from the Flash ROM on the Motherboard and LCD Relay PCB.
You have to compare the Model No./Serial No. on the Name Plate and this information.
If the Model No./Serial No. on the Name Plate and this information are different, something are
wrong.
PE Diag checks the specifications (CPU Type, Chipset Type, Display Size and Touch Panel Type) for
read Model No.
If read Model No. is correct of all specifications, it shows mark.
If read Model No. is not correct of any specifications, it shows mark.
If it shows mark, you have to check actual specifications.
2-1. M/B
Main Body
2-2. LCD
Display Module.
3. Function Buttons
3-1. Shut down
It shuts down of the JS-960Wx.
3-2. Quit
It quits the PE Diag Program.
3-3. Version = x.xx
PE Diag Program Version.
3-4. Diag_Setting.ini Edit
Edit 960WSDiag_Setting.ini File.
3-5. Diag_Setting.ini Revert
Load 960WSDiag_Setting_Default.ini.
4. Hardware Monitor
PE Diag read the hardware status data automatically at startup of PE Diag.
If the status are in the specifications, it shows mark.
If the status are out of the specifications, it shows mark.
If it shows mark, you have to check the actual hardware status.
－3-8－
To Next Page
Loading...
