To Next PageTo Next Page
Need help?Do you have a question about the Panasonic JS970 and is the answer not in the manual?
General| Brand | Panasonic |
|---|---|
| Model | JS970 |
| Category | Touch terminals |
| Language | English |
Outlines the contractor's duty to complete pre-installation preparations to avoid delays and extra charges.
Install specific orange isolated ground (IG) electrical receptacles as per enclosed specifications.
Install CAT5 data communications cable according to enclosed specifications for network connectivity.
Install a CAT5 data cable from the network switch to the burger chute order printer.
Install CAT5 cable for the kitchen video monitor system (KVS) video feed.
Install CAT5 cable for the kitchen video monitor system (KVS) bump bar connection.
Install a 30-foot audio cable connecting the bump bar to the Grill Monitor.
Install KVS monitor mount brackets, referring to building plans for locations.
Cut 1 1/2" holes in counters for cable passage, centered where the cash register sits.
Specifies the physical dimensions of the cash drawer for placement and integration.
The entire system must be on a single, dedicated 120V, 60Hz, 15-amp, 3-wire circuit.
Details AC wiring specifications for the POS system, including dedicated lines and breaker size.
Lists all required locations for the orange duplex, 3-wire grounded receptacles.
Lists electrical practices and equipment that are not permitted on the system circuit.
Informs about the cable's FT6 Plenum rating and the need to call if higher rating is required.
Details requirements for CAT5 data communications cable used for Ethernet connections.
Specifies cabling practices that must be avoided, such as proximity to electrical interference sources.
Illustrates the network layout for the touch screen POS system, showing device connections.
Specifies CAT5e cable type and color for network connections.
Standard practice to leave 6 feet of cable at each location for termination by QSR.
Indicates the typical location of the network rack and patch panel.
Highlights that the CAT5 BLACK cable is specifically for the video monitors.
Specifies the use of CAT5 Black cable for video monitor connections.
Specifies the use of CAT5 White cable for the bump bar connection.
Specifies the use of a 30-foot audio cable for connections.
Indicates the typical location of the Video Splitter and E-Pic Video Controller.
Provides the physical dimensions for the drive-thru display unit.
Provides the physical dimensions for the drive-thru speaker post.
Specifies electrical requirements for the drive-thru speaker post, including power and data.
Details installation instructions for the drive-thru speaker post slab and conduit requirements.
Lists devices, their IP addresses, and assigned ports on the network switch and router.
Details port assignments for various system components on the 24-port switch and router.
Outlines port assignments for devices on the Keystone 48-port cut-out panel.
