Items Adjustment
Point
Procedure* Check or
Replace Parts
(
Transmit Audio Check
and Confirmation
TP15 1. Configure the DECT tester (CMD60) as follows;
<Setting>
Test mode: FP
Mode: Normal
RFPI: 0102030405
2. Execute the command "testmode".
3. Execute the command "regcmd60".
4. Initiate connection from DECT tester.
5. Execute the command "openaudio".
6. Confirm that the value of EEPROM address "F3F" is "02". (If the value is not
"02 (by User)", set "02" and power off and power on, and return to clause 2.)
7. Input audio signal (30mVrms/1kHz tone) to DECT tester.
<DECT tester setting>
Scramble: On
AF Gen to ADPCM: Off
AF Meter Input: ADPCM
AF Gen Frequency: 1000Hz
AF Gen Level: 30mVrms
8. Confirm hearing tone: 300mV ± 250mV (Just check Audio path)
9. Confirm that the audio distortion with DECT tester is < 5 %.
IC1,C8,R7,
R8,C6,C7,
C5,R5,R1,
C4,IC3,C54,
C66,C60,L3,
C57,C55,C56,
C62,R23,R24,
C63,C64,C65,
R18
Note:
After the measuring, sock up the solder of TP.
*:
PC Setting (P.38) is required beforehand.
The connection of adjustment equipment are as shown in
Adjustment Standard (Handset) (P.49).
48
KX-TCD4 10RUM / KX-TCD410RUS / KX-TCD412RU M / KX-TC D412RUS / KX-A141RUM / KX-A141RUS / KX-A142RUM / KX-A142RUS
To Next Page
Loading...
