Panasonic KX-E2000

USING
THE TYPEWRITER
Automatic Paper
Insertion
The Panasonic
typewriter is
pre-programmed to insert your paper
seven
(7)
lines from
the top
of
the
page. Place
your paper in
the machine and
pull
the
paper bail
release
lever
toward you
until the paper begins to
insert.
Changing
the Paper Insertion Position
1
Place your paper against
the paper support guide
with
the left
edge
of
the
page
aligned with
0 on the margin scale (located
on
the lop cover)
2 Pull the Paper Bail
Release
Lever
towards
you
until
the
paper
begins to
insert
3
Press
RETURN. INDEX
(i)
or REVERSE
INDEX (T) to position
the paper
at the desired insertion
point
4 Press
CODE
+ A
The
new
position is
now
stored and
will
remain the point
of
insertion until you change the setting again by
following
the
steps
outlined above.
NOTE:
You can reset the auto
paper
insertion point to the default setting
(7
lines) by changing
the default parameter
(refer
to page 37).
Automatic
Paper
Eject
After typing a project, you can instruct your
typewriter
to au-
tomatically eject the paper.
Automatically Ejecting
the Paper
E
•
Press
CODE + E
The KX-E2000 has been
pre-programmed for standard
81/^x11"
paper
(66
lines),
and
will
eject the paper based on that setting.
If
you are using
legal or ledger size
paper
(longer than II"),
the paper will
not
eject fully from the typewriter unless
you
change the paper
length
default setting (see page
37).
9