Features Summary
52
Advanced features!
How to set menu options
Programming table
Code
#22
To print the journal report
automatically for fax communications.
AUTO JOURNAL
MODE=ON [±]
ON
OFF
To send a document:
1. Insert the document.
2. Follow steps 1 and 2 above.
3.
Press or
to select “ON”.
4. Press .
5. Enter the fax number.
6. Press .
7. Enter the transmission start time.
Press to select “AM” or “PM”.
8. Press .
9. Press .
●
To cancel after programming,
press then
.
“NEXT FAX”: This setting is effective
only for the next attempted fax
transmission. After transmission, the
unit will return to the previous setting.
“ERROR”: When the previous fax
transmission fails and you redial
the same number.
●
This feature is not available for
broadcast transmission.
●
The calling charge may be higher.
#23
If you have difficulty sending an
overseas fax, activate this feature
before starting transmission. This
feature makes sending documents
easier as the transmission speed is
slowed down.
OVERSEAS MODE
MODE=ERROR [±]
Display & Feature Settings How the unit operates
#25
To send a fax automatically at a
specified time.
This allows you to take advantage
of low-cost calling hours offered by
your telephone company.
●
The setting can be reserved to
take place up to 24 hours in
advance.
DELAYED SEND
MODE=OFF [±]
NEXT FAX
ERROR
OFF
ON /
fax no. /
hh:mm
OFF
(The default setting is in bold type.)
“ON”: The unit will print the journal
report automatically after every 30
new fax communications (p. 31).
Note:
●
Step 3 may be slightly different
depending on the feature.
●
See page 49 for more details.
1. Press .
2. Press or until the following is
displayed.
Press and press or until
the desired feature is displayed.
To Next Page
Loading...
