7. Programmable Features
35
7.2 Basic features
Feature Feature code Selection
Setting the date and
time
{#}{0}{1} Enter the date and time using the dial keypad. See page 13 for
details.
Setting your logo {#}{0}{2} Enter your logo using the dial keypad. See page 14 for details.
Setting your fax
number
{#}{0}{3} Enter your fax number using the dial keypad. See page 15 for
details.
Printing a sending
report
{#}{0}{4}{0} “OFF”: Sending reports will not be printed.
{1} “ON”: A sending report will be printed after every fax
transmission.
{2} “ERROR” (default): A sending report will be printed only when
a fax transmission fails.
Changing the ring
count in FAX ONLY
mode (KX-FP207 only)
{#}{0}{6}{1} “1”
{2} “2” (default)
{3} “3”
{4} “4”
{5} “5”
{6} “6”
{7} “7”
{8} “8”
{9} “9”
Changing the ring
count in FAX ONLY
mode (KX-FP218 only)
{#}{0}{6}{1} “1”
{2} “2” (default)
{3} “3”
{4} “4”
{5} “5”
{6} “6”
{7} “7”
{8} “8”
{9} “9”
Note:
L Set feature #77 to “FAX ONLY” (page 40) beforehand.
Changing the ring
count in TAM/FAX mode
(KX-FP218 only)
{#}{0}{6}{0} “TOLL SAVER”
{2} “2” (default)
{3} “3”
{4} “4”
{5} “5”
{6} “6”
{7} “7”
See page 26 for details.
Note:
L Set feature #77 to “TAM/FAX” (page 40) beforehand.
Changing the maximum
recording time for
incoming messages
(KX-FP218 only)
{#}{1}{0}{0} “GREETING ONLY”: The unit plays the greeting message but
does not record any incoming messages.
{1} “1 MINUTE”: 1 minute
{2} “2 MINUTES”: 2 minutes
{3} “3 MINUTES” (default): 3 minutes
FP207-218FX-PFQX2515ZA-en.book Page 35 Friday, June 30, 2006 11:58 AM
To Next Page
Loading...
