1. Introduction and Installation
9
L Make sure the blue gear (2) and white gear (3)
are installed as shown.
5 Turn the blue gear (4) in the direction of the arrow
until the ink film is tight (5) and at least one layer of
ink film is wrapped around the blue core (6). 6 Close the back cover securely by pushing down on
the dotted area at both ends (7).
7 Close the front cover securely.
3
2
4
5
Correct
Incorrect
6
Tight
1 turn
No ink film is wrapped around the blue core.
Slack/Crease
Reverse
7
FP207-218FX-PFQX2515ZA-en.book Page 9 Friday, June 30, 2006 11:58 AM
To Next Page
Loading...
