Panasonic KX-FPC95

65
Receiving Faxes
Pager call - when the unit receives a fax
or voice message!
This feature allows your unit to call your pager when your unit receives a fax document or an
incoming voice message.
●
If you have subscribed to a Caller ID service, your pager will display the caller’s
telephone number before the number “11” or “22” (see below).
1
Press .
Display:
2
Press , then .
3
Press .
4
Rotate to select “ON”.
●
If this feature is not required, select “OFF”.
5
Press .
6
Enter your pager number.
●
You can enter a total of 46 digits and/or
pauses.
Example:
1 202 555 1234PP12345678PP
7
Press .
●
The unit will dial the stored number.
8
Check that your pager receives a pager test
call.
9
Press .
DIGITAL SP-PHONE
12PAGER1TEST
SET
NO.=
SET
MODE=ON
JOG DIAL
MODE=OFF
SET
PAGER1CALL
7 0
1.SYSTEM1SET1UP
MENU
SET
REDIAL/PAUSE
(Pause)
JOG DIAL
MENU
Display
DIGITAL SP-PHONEDIGITAL SP-PHONE
Your pager
number
Pauses
Your pager access
code, if required.
Your pager will beep and display as follows;
— “11” : when your unit receives a voice
message.
— “22” : when your unit receives a fax
document.
Pager
22
Example:
Your unit received
a fax document.
When your pager receives a pager call