Panasonic KX-FT901CX-B

Code Function Set Value Effective Range Default Remarks
594 Setting the overseas DIS
detection
1: Detects on the 1st
time.2: Detects on the
2nd time.
1, 2 1 Sets the recognition format of the DIS signal.
1:Detects the first DIS signal sent from the
receiver during FAX transmission. 2:Ignores
the first DIS signal sent from the receiver during
FAX transmission. (See "5. Unit can copy, but
cannot transmit/receive long distance or
international communications" in DEFECTIVE
FACSIMILE SECTION (P.64).)
595 Setting an acceptable
reception error value
001~999 X number of
times
001~999 100 Sets the number of acceptable error lines when
the FAX reconstructs the received data.
596 Setting the transmit level - 15~00 15~00 10 dBm Selects the FAX transmission level.
598 Receiving Sensitivity - 43dBm 20~48 42 (See "5. Unit can copy, but cannot
transmit/receive long distance or international
communications" in DEFECTIVE FACSIMILE
SECTION (P.64).)
710 Memory clear except
History data
To reset the value to the default one, except
History data. Please restart a power supply
after clearing a memory.
717 Transmit speed select 1:9600BPS
2:7200BPS
3:4800BPS
4:2400BPS
1~4 1 Adjusts the speed to start training during FAX
transmission.
718 Receive speed select 1:9600BPS
2:7200BPS
3:4800BPS
4:2400BPS
1~4 1 Adjusts the speed to start training during FAX
reception.
719 Ringer off in TEL/FAX
mode
1:ON 2:OFF 1, 2 1 Sets the ringer switch off when a call is
received in the TEL/FAX mode.
721 Pause tone detect 1:ON 2:OFF 1, 2 1 Selects the tone detection for pauses in dialing.
722 Redial tone detect 1:ON 2:OFF 1, 2 1 Selects the tone detection mode after redialing.
731 CPC mode 1:A 2:B 3:OFF 1, 2, 3 1 Set the CPC signal detection mode from the
converter.
763 CNG detect time 1:10 sec 2:20 sec
3:30 sec
1, 2, 3 2 Selects the CNG detection time of friendly
reception.
771 T1 timer 1:35 sec 2:60 sec 1, 2 1 Sets a higher value when the response from
the other party needs more time during FAX
transmission.
774 T4 timer 00~99 00~99 00
775 Monitoring of message
transfer
1:ON 2:OFF 1, 2 2 If set to ON a message can be monitored from
this unit´s SP-PHONE when transferring a
message.
784 Voice prompt test You can hear the voice prompt from speaker
after pressing "START" key.
815 Sensor check Press "START/SET".
874 DTMFontime 060~200ms 060~200 090 ----------
875 DTMFofftime 060~200ms 060~200 090 ----------
882 Journal 3 list See PRINT TEST PATTERN (P.46).
44
KX-FT901CX-B / KX-FT903CX-B / KX-FT901CX-W / KX-FT903CX-W / KX-FT901CX-S / KX-FT903CX-S