Panasonic KX-HDV130 - Checking the Firmware

9 | Page
© Nextiva, All Rights Reserved
10. Click Save & Continue. A pop-up message appears confirming that the transaction has been
processed (Figure 3-5).
Figure 3-5: Confirmation Message
Checking the Firmware
Before attempting to provision a Panasonic KX-HDV130 phone using the instructions below, make sure
that the phone is on firmware version 2.040 or higher. If it is on an older version of the firmware, the
phone may fail to register or be unable to make/receive calls.
1. From the main screen of the phone, select Menu

Basic Settings

Other Option

Embedded Web

On. The phone will beep, indicating Embedded Web is now on.
2. Press the Back softkey (left softkey) twice to go back to the main menu.
3. Select System Settings

Status

IPv4 Settings

IP Address. Record the IP Address that
appears on the screen.
4. Use your web browser to navigate to the IP Address of the phone (Figure 3-17).
Figure 3-17: Navigate to the IP Address
5. Enter admin as the username and adminpass as the password (Figure 3-18).
Figure 3-18: Log in to the Phone Interface