Panasonic KX-HDV230 - Page 20

KX-HDV230 / KX-HDV20
*1
*4
*6
*3
*5
*2
*1
PoE HUB
*2
LAN cable
*3
Optional AC adaptor
*4
Optional headset
For up-to-date information about headsets that have been tested with this unit, refer to the following web sites:
https://panasonic.net/cns/pcc/support/sipphone/
*5
Connection cable
Connect the connection cable as shown in the illustration.
*6
Optional EHS headset
For up-to-date information about EHS headsets that have been tested with this unit, refer to the following web site:
https://panasonic.net/cns/pcc/support/sipphone/
Note
• The initial setting for the IP address is "DHCP–Auto". For information about your network
environment, contact your administrator.
When selecting Ethernet cables (not included)
• Use flexible cables without jack covers. Do not use cables with a hard coating that may tear or crack
when bent. To prevent damage to the cables, use cables that do not protrude from the bottom of the
base.
• Connect the cables as shown in the following illustration.
2.2.5 Connections (including optional KX-HDV20)
20 Operating Instructions Document Version: 2017-08