Front door camera and outdoor camera setup
Front door camera and outdoor camera setup (overview)
There are 4 basic steps you need to perform in order to access the access point and your cameras from
your mobile device.
Connections
¯
Connect your access point to a power outlet and to your wireless
router.
*1
Download
¯
Download the [HomeHawk] app to your mobile device.
Initial setup
¯
Use the [HomeHawk] app to register your mobile device to the
access point.
Register devices Add more mobile devices (smartphones and tablets) or cameras to the
system.
*1 Refer to the Installation Guide included with your access point for more information.
Initial setup
Before you begin
Confirm the following before you begin.
– Make sure you have installed the [HomeHawk] app on your mobile device
– Make sure your wireless router and the access point are turned on and the access point’s LED
indicator is lit in amber or green
– Make sure your access point is connected to your wireless router with an Ethernet cable
– Make sure your mobile device is connected to the same wireless router as your access point
– Make sure your mobile device can connect to the Internet
Note:
R If you have completed this procedure and want to register another mobile device to the access point,
see “Registering other mobile devices to the access point”, Page 82.
R If you experience trouble while performing this procedure, refer to the information in “Sometimes I
cannot connect while at home”, Page 138.
Initial setup
1 Start the [HomeHawk] app by tapping its icon (shown below).
R The end-user license agreement is displayed the first time you start the app.
2 Follow the on-screen instructions.
81
Using a front door camera and outdoor camera
To Next Page
Loading...
