Panasonic KX-HNB700 - Device LED indicators; Access point LED indicator

The selected mode was changed
An error occurred
The shelf camera’s or floor camera’s sound sensor was triggered
The shelf camera’s or floor camera’s temperature sensor was triggered
The shelf camera’s or floor camera’s privacy mode was enabled
The shelf camera’s or floor camera’s privacy mode was disabled
Device LED indicators
Each device can provide information about its status by turning on its LED indicator.
Meaning of symbols used in this section
Indicator off
Indicator lit
Indicator blinking slowly
Indicator blinking
Indicator blinking quickly
Indicator blinking very quickly
Indicator blinking slowly in two colors
Indicator blinking in two colors
Access point LED indicator
Off
No power, or LED indicator is turned off
*1
Green
Power is on (normal operations)
*1
, or registration completed for the
camera or mobile device
Registration mode, updating
Obtaining an IP address, or accessing a microSD card
*1
Green or amber
(alternating)
or
Starting up
*2
Red Registration failed
Amber Power on until start up completed
25
Getting started with the HomeHawk!