*1 You can configure the camera so that its LED indicator does not light in most states. See “Status”,
Page 70.
*2 The signal level (strong, good, weak, out of range) is shown after pressing the SETUP button for 3
seconds. You can also check the signal level from “Camera signal strength”, Page 70.
*3 Lights for 3 seconds after registration is successfully completed or failed.
Shelf camera LED indicator
Off R No power
R LED indicator is turned off
*1
Green
Registration successfully completed
*3
or signal level is strong
*2
Registration mode, updating
Camera is searching for your wireless router
Red
Registration failed
*3
, signal level is weak
*2
R Streaming data
*1
or detecting motion
*1
R Accessing microSD card (when privacy mode is off)
R Camera is out of range of your wireless router
*2
R Wireless LAN connection failed
Yellow Not registered to your wireless router (usually for initial setup), or signal
level is good
*2
Initial setup is being performed using WPS on your router
Blue Registration to your wireless router successfully completed or camera is
on
*1
White
Privacy mode is on
*1
Accessing microSD card (when privacy mode is on)
*1 You can configure the camera so that its LED indicator does not light in most states. See “Status”,
Page 70.
*2 The signal level (strong, good, weak, out of range) is shown after pressing the SETUP button for 3
seconds. You can also check the signal level from “Camera signal strength”, Page 70.
*3 Lights for 3 seconds after registration is successfully completed or failed.
System expansion
System expansion (overview)
You can expand the system by registering additional devices. See “What kinds of devices are
available?”, Page 6 for information on the types and number of devices that can be registered.
28
Getting started with the HomeHawk!
To Next Page
Loading...
