IP address is not obtained, or Ethernet cable is not connected to the
router
*1 You can configure the access point so that its LED indicator does not light in most states. See
“Status LED”, Page 99.
*2 It may take some time for the access point to finish starting up.
Front door camera and outdoor camera LED indicator
Off R No power
R More than 5 seconds have passed since turning on the power when
the camera is not registered to the access point
R LED indicator is turned off
*1
Green
Registration successfully completed or signal level is strong
*3
Registration mode, updating
Camera is searching for an access point
*1
Green or amber
blinking quickly -
off for 1 second
or
Camera is on
*1
Red
Registration failed, signal level is weak
*3
, or detecting motion
*1,
*4
Camera is out of range of the access point
*1,
*3
Streaming data
*1
Amber
Not registered to the access point
*2
, or signal level is good
*3
Battery is running low
*1
*1 You can configure the camera so that its LED indicator does not light in most states. See “Status
LED”, Page 99.
*2 The LED indicator lights in amber for 5 seconds after the power is turned on for the camera.
*3 The signal level (strong, good, weak, out of range) is shown after pressing the SETUP button for 3
seconds. You can also check the signal level from “Camera signal strength”, Page 95.
*4 Motion detection can also be checked from “Detection test”, Page 98.
Front door camera and outdoor camera charging LED indicator
Red Charging is completed
Charging
Charging failure
HD camera LED indicator
Off
No power, or LED indicator is turned off
*1
26
Getting started with the HomeHawk!
To Next Page
Loading...
