2. Enter the Configuration ® Wireless ® WLAN page. Key in the same wireless settings as those on your
router/AP (SSID, Wireless mode, Encryption type, and Pre-shared key).
3. When done, click the Save button, disconnect the Ethernet cable and then reboot the KX-NTV150 (by
disconnect and then connect the power cord). The KX-NTV150 should then be connected over the wireless
network. If successfully configured, the KX-NTV150 LED should blink with Orange color every 0.5 seconds.
If after booting up for 1 minute, the KX-NTV150 LED does not turn Green within 2 minutes, check your
wireless configuration for errors.
40 User’s Manual
2 Software
To Next Page
Loading...
