2. WEP (Wired Equivalent Privacy): This allows communication only with other devices with identical WEP
settings.
• Authentication mode: Choose one of the following modes. The default setting is "Open".
Open: Communicates the key across the network.
Shared: Allows communication only with other devices with identical WEP settings.
• Key length: The administrator can set the key length to 64 or 128 bits.
The default setting is "64 bits".
• Key format: Hexadecimal or ASCII. The fault setting is "HEX".
HEX digits consist of the numbers 0~9 and the letters A-F.
• Network key: Enter a key in either hexadecimal or ASCII format.
You can select different key lengths, the acceptable input lengths are as follows:
64-bit key length: 10 Hex digits or 5 characters.
128-bit key length: 26 Hex digits or 13 characters.
User’s Manual 91
2 Software
To Next Page
Loading...
