Issue 219
Installing the Card Holder
The KX-T7130E, KX-T7020E and KX-T7050E are equipped with a card holder with a memory station card. Follow the
instructions below to install the card holder to the unit.
1 Match the marks the slide rails on the on the card
holder and on unit.
2 Push two shaded portions slightly and insert the edges of
the holder under the slide rails and then slide down in
direction of arrow "A".
Removing the card holder:
Push the card holder in the direction of arrow "B" while
keeping the tip of the holder pulling in the direction of
arrow "C".
To Next Page
Loading...
