Before Operating the Handset
10
Adjusting the Vibrate Setting
Adjusting the Receiver/Speaker/Headset Volume
• You can receive an intercom call by the caller’s voice instead of rings (Voice
Call). For further information, refer to “Alternate Receiving—Ring/Voice” in the
user documentation for your PBX.
• To set Vibrate only, without ringing, select Vib.& Ring and set the Ringer Volume
to off, or turn Meeting Mode on. (See page 5, 9.)
Select the desired setting.
(Vib.& Ring / Vib. Ring / Off)
Select “Incoming
Option”.
Press the
Joystick.
Press the
Joystick.
Press the
Joystick.
Press the
Joystick.
Press the
Joystick.
Select
“Vibrate”.
Select “
Setting Handset”.
During a conversation
Move the Joystick UP or DOWN to adjust the volume.
(Receiver Volume-Level 1-4, Speaker Volume-Level 1-6, Headset Volume-Level 1-4)
To Next Page
Loading...
