Panasonic KX-TCD210E

SMS (Short Message Service)
39
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Example: The other party’s phone
number is 123456 and their mailbox
number is 1.
Enter 1234561.
If you do not enter the other party’s
mailbox number, the message will be
sent to the public mailbox.
7 To save the message, select “Yes”,
then press {>}.
L To send the message without saving it,
select “No”, then press {>}.
8 To send the message, select “Send”,
then press {>}.
L To cancel sending, press {ih}.
Note:
L This unit supports SMS messages of up to
612 characters, however, the maximum
number of characters you can send or
receive may be limited by your SMS
service provider. Consult your SMS
service provider for details.
L If your message contains over 160
characters, “@@Long Message@@” is
displayed. Your service provider may treat
long messages differently from other
messages. Consult your service provider
for details.
L “Invalid Number” is displayed if you
try to send a message to a phone number
saved in the handset phonebook, caller
list, or redial list that is over 20 digits long.
L When sending a message, “Sending
Message” is displayed momentarily, then
“Transferring Message” is
displayed.
L If your phone is connected to a PBX, store
the PBX line access number (page 42).
Sending a saved message
1
Press {j/OK}.
2 Select “SMS”, then press {>}.
3 To access the public mailbox
Select “Public”, then press {>}.
To access a private mailbox
Select the desired mailbox, press {>},
then enter its password.
4 Select “Send List”, then press {>}.
5 To read a saved message, press {e} or
{v} repeatedly to select the message,
then press {j/OK}.
L Messages are displayed in
chronological order and by destination
phone number.
6 To send the message, press {j/OK},
select “Send”, then press {>}.
7 Press and hold {C/T} to erase all
numbers, then continue from step 6,
“Writing and sending a new message”,
page 38.
Editing and sending a saved
message
1
Press {j/OK}.
2 Select “SMS”, then press {>}.
3 To access the public mailbox
Select “Public”, then press {>}.
To access a private mailbox
Select the desired mailbox, press {>},
then enter its password.
4 Select “Send List”, then press {>}.
5 Press {e} or {v} repeatedly to select
the message, then press {j/OK}.
6 Press {j/OK}, select “Edit
Message”, press {>}, then continue
from step 5, “Writing and sending a new
message”, page 38.
Erasing saved messages
1
Press {j/OK}.
2 Select “SMS”, then press {>}.
3 To access the public mailbox
Select “Public”, then press {>}.
To access a private mailbox
TCD210220E(e-e).book Page 39 Tuesday, January 18, 2005 9:44 AM