Panasonic KX-TCD210E

SMS (Short Message Service)
38
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Message Centre 1 is used for sending SMS
messages, and Message Centre 2 is used
for receiving messages.
L Consult your service provider for more
information.
1 Press {j/OK}.
2 Select “SMS”, then press {>}.
3 Select “Public”, then press {>}.
4 Select “Settings”, then press {>}.
5 Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page
33).
6 Select “Message Centre1” or
“Message Centre2”, then press {>}.
7 Edit the number as necessary, then
press {j/OK}.
8 Select “Save”, then press {>}.
9 Press {ih}.
Note:
L If your phone is connected to a PBX, you
need to add the PBX line access number
and a dialling pause to the beginning of
the Message Centre 1 phone number.
Registering mailboxes
Each SMS mailbox you wish to use must be
registered with BT Text. There are two ways
you can register a mailbox:
– Send an SMS message to another
person.
– Send the text message ‘REGISTER’ to
destination number 00000.
Sending a message
Writing and sending a new
message
1
Press {j/OK}.
2 Select “SMS”, then press {>}.
3 To access the public mailbox
Select “Public”, then press {>}.
To access a private mailbox
Select the desired mailbox, press {>},
then enter its password.
4 Select “Create”, then press {>}.
L If “^Use Last Text?” is displayed,
you can use the text from the last
message you created by pressing
{e}. This message will be displayed
only if the last message was created
using the same mailbox you selected
in step 3.
5 Enter the message (page 43), then
press {j/OK}.
6 Enter the destination phone number (20
digits max.), then press {j/OK}.
L To send the message to a party saved
in the handset phonebook, press
{k}, select the handset phonebook
entry, then press {j/OK} 2 times.
L To send the message to a party logged
in the caller list, press {e} or {v}
repeatedly to select the party, then
press {j/OK} 2 times.
L To send the message to a phone
number logged in the redial list, press
{R} repeatedly to select the phone
number, then press {j/OK} 2 times.
L If you wish to send the message to the
other party’s mailbox, enter the other
party’s mailbox number after the
destination phone number.
TCD210220E(e-e).book Page 38 Tuesday, January 18, 2005 9:44 AM