* : If the current 4-digit PIN is forgotten, press and
you will be able to enter new PIN.
6.3.3. Reset Base Unit PIN to Default (0000) -When There is NO Handset
Registered-
6.3.3.1. Symptom
There is no way to reset base PIN when there is no handset registered to the base.
6.3.3.2. Thinkable Situation
- Customer may ask to reset base PIN because they forget it.
- Customer may bring only a base unit for repair and there is no
handset registered to the base (Need to register another handset
to the base to confirm if the unit works properly after repair).
- When original handset has broken and customer purchased a new
one, if customer forget base PIN, customer cannot register the new
handset and may ask to reset the PIN.
6.3.3.3. Remedy
<Preparation>
Refer to JIGs and PC ().
<Connection>
1. Solder a pin or lead wire to GND, SDA, and SCLK on base PCB.
2. Plug in AC adaptor to the base.
3. Turn on the power to the JIG (9V).
4. Then connect the cable to each pins using clip.
As for the connection between JIG and PCB, see below photos.
<PC setting and how to reset base PIN to default (0000)>
1. Refer to PC Setting ().
2. Next, execute <initbspin.bat> by typing "initbspin". The PC display
will be shown as below.
3. After that, turn off DC power supply (9V) to the jig, unplug AC
11
www.freeservicemanuals.info
Digitized in Heiloo, Holland
To Next Page
Loading...
