If entered incorrectly, an error tone
sounds.
If entered correctly, a confirmation
tone sounds.
! Once you have programmed
the password, you cannot con-
firm it. We recommend you
write down the password. If
you forget it, please consult our
Panasonic Customer Care
Helpline.
U.K. 08700 100 076
R.O.I. 01289 8333
14 Helpline Tel.No. : U.K. 08700 100 076 R.O.I. 01289 8333
Base Unit Settings
Set the 4 - Digit Base
Unit PIN
Select Pause Timing
You can restrict selected handset(s)
from dialling selected phone
numbers. You can assign up to 6 call
restriction numbers (up to 8 digits).
ZZFF
.
Enter PIN.
All registered handset numbers are
displayed.
ZZAA -- FF
to select
handset(s) to restrict.
The selected handset(s) will flash.
ZZVV
.
Enter a restriction number (max.
8 digits).
(If you misdial ZW).
ZZYY
to confirm restriction
number.
To continue entering call restriction
numbers (max. 8 digits), enter the
number, then
ZZYY
.
On completion,
ZZYY
.
! If you dial a restricted
number, the call does not
connect and restricted number
flashes.
Cancel Call Restricted
Handset(s)
ZZFF
.
Enter PIN.
ZZAA
-
FF
to select
handset(s) to cancel.
The selected handset(s) will stop
flashing.
ZZVV
.
Set Call Restriction
You can set the pause timing to 3 or
5 seconds, depending on your PBX
requirements (see “Dialling Pause”).
ZZCC
.
Enter PIN.
ZZCC
.
ZZAA
to select 3 seconds
OR
ZZBB
to select 5 seconds.
ZZVV
.
You can change the 4-digit password
for the base unit. The factory preset
is 0000.
ZZEE
.
Enter PIN.
Enter New PIN (4 digits) twice.
Before programming, please follow steps 1 to 3 of ‘Base Unit Settings’.
To Next Page