EasyManua.ls Logo

Panasonic KX-TG1105RUS - 10 Things to Do after Replacing IC; Base Unit; Handset

Panasonic KX-TG1105RUS
87 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10 THINGS TO DO AFTER REPLACING IC
Cautions:
Since this page is common to each country, it may not apply to some models in your country. The contents below are the
minimum adjustments required for operation.
10.1. Base Unit
Before doing the following adjustment, be sure to do PC Setting (P.28) in The Setting Method of JIG (Base Unit).
IC Necessary Adjustment
BBIC Programs for Voice processing, interface for RF and
EEPROM
1. Clock adjustment: Refer to Check Point (E). (*1)
EEPROM Adjustment parameter data
(country version batch file, default batch file, etc.)
1. Default batch file: Execute the command Default4KB.
2. Country version batch file: Execute the command
1100XXvYY.(*2)
3. Clock adjustment: Refer to Check Point (E). (*1)
Note:
(*1) Refer to Check Point (Base Unit) (P.23)
(*2) XX: country code, YY: revision number
XX and YY vary depending on the country version. You can find them in the batch file, PQZZ- mentioned in JIGs and PC
(P.28).
10.2. Handset
Before doing the following adjustment, be sure to do PC Setting (P.36) in The Setting Method of JIG (Handset).
IC Necessary Adjustment
BBIC Programs for Voice processing, interface for RF and
EEPROM
1. Clock adjustment: Refer to Check Point (H). (*3)
2. 4.0 V setting and battery low detection: Refer to Check Point
(A), (F) and (G). (*3)
EEPROM Adjustment parameter data
(country version batch file, default batch file, etc.)
1. Default batch file: Execute the command Default.
2. Melody Initialize batch file; Execute the Command D45MFA.
3. Country version batch file: Execute the command
110XXvYY.(*4)
4. Clock adjustment: Refer to Check Point (H). (*3)
5. 4.0 V setting and battery low detection: Refer to Check Point
(A), (F) and (G). (*3)
Note:
(*3) Refer to Check Point (Handset) (P.33)
(*4) XX: country code, YY: revision number
XX and YY vary depending on the country version. You can find them in the batch file, PQZZ- mentioned in JIGs and PC
(P.36).
39
KX-TG1105RUS / KX-TG1105R UT / KX-TG1106R US / KX-TG1106R UT / KX-TGA110RUS / KX-TGA110RUT

Table of Contents

Related product manuals