Programmable Settings
38 For assistance, please call 1-800-211-PANA (7262).
Note:
L The setting should stay at 700 ms unless
pressing {Flash} fails to pick up the Call
Waiting call.
L If the unit is connected via a PBX, certain
PBX functions (call transferring, etc.)
may not work correctly. Consult your
PBX supplier for the correct setting.
Line mode
The line mode is preset to “B” and
generally should not be adjusted. If “Line
in use” on the handset is not displayed
properly, the line mode selection is
incorrect. Set line mode to “A”.
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “Set tel line” by pressing
{V} or {^}, then press {>}.
4 Scroll to “Set line mode” by pressing
{V} or {^}, then press {>}.
5 Press {V} or {^} repeatedly to select
the desired setting.
6 Press {Save}, then press {OFF}.
Other options
Handset key tone
You can select whether or not key tones
are heard when keys are pressed.
Includes confirmation tones and error
tones. The default setting is ON.
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “Key tone” by pressing {V} or
{^}, then press {>}.
4 Press {V} or {^} repeatedly to select
“On” or “Off”.
5 Press {Save}, then press {OFF}.
Re-registering the handset
If “No link to base. Move closer
to base, try again.” is displayed
even when the handset is near the base
unit, you may need to re-register the
handset to the base unit.
Important:
L Make sure the base unit is not being
used.
L Have the handset and base unit near
each other when re-registering the
handset.
L KX-TG2432 only:
Confirm the extension number of the
handset which has lost the
communication by placing the handset
on the base unit or charger.
If you re-register the handset using the
other handset’s extension number [1]
or [2], the other handset will not
function.
TG2431_2432(e).book Page 38 Thursday, February 3, 2005 5:01 PM
To Next Page
Loading...
