Liquid damage
Problem Cause/solution
Liquid or other form of
moisture has entered the
handset/base unit.
R Disconnect the AC adaptor and telephone line cord from the
base unit. Remove the batteries from the handset and leave to
dry for at least 3 days. After the handset/base unit are
completely dry, reconnect the AC adaptor and telephone line
cord. Insert the batteries and charge fully before use. If the unit
does not work properly, contact an authorised service centre.
Caution:
R To avoid permanent damage, do not use a microwave oven to speed up the drying process.
Registering a handset to the base unit
1 Handset:
M
N#130
2 Base unit:
Press and hold M N for about 5 seconds.
R If all registered handsets start ringing, press M
N again to stop, then repeat this step.
(KX-TGC262/KX-TGC263/KX-TGC264)
3 Handset:
MOKN a Wait until “Base PIN” is displayed. a Enter the base unit PIN (default: “0000”).
a MOKN
R If you forget your PIN, see page 41.
Deregistering a handset
1 M N#131
R All handsets registered to the base unit are displayed.
2 MbN: Select the handset you want to cancel. a MOKN
3 MbN: “Yes” a MOKN a M
N
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
43
Useful Information
To Next Page
Loading...
