Other settings
Message indicator
T
he message indicator is located on top of the
handset and informs you of the following
status with its flashing.
Indicator Status
Flashing
r
apidly
– Incoming call is now being
received. (page 14)
– An alarm sounds.
(page 27)
Flashing
s
lowly
*1
– There are missed calls.
(page 32)
*1 To activate, setting of message indicator
m
ust be “On”. (page 13)
Setting the message indicator
T
he message indicator for the following
feature must be “On”.
– “Missed Call” (Default: Off)
1 M
N#278
2 M N
R “ ” is displayed next to the selected
f
eature.
R To cancel a selected feature, press
M
N
again. “
” disappears.
3 MO
KN a M
N
N
ote:
R If the message indicator flashes when the
handset is not placed on the base unit,
battery consumption is faster than usual.
Eco mode setting
Y
ou can select the desired eco mode setting
by pressing MR/ECON.
The following settings are available for eco
mode.
– “Eco”: Reduces the base unit transmission
power by up to 90 % in standby mode.
When this setting is selected,
is
d
isplayed on the handset display instead of
.
– “E
co Off” (default setting): Turns off eco
mode.
When this setting is selected,
is not
d
isplayed in the handset display.
Note:
R When eco mode is active, the range of the
base unit is reduced in standby mode.
R If you set repeater mode to “On”
(page 31):
– Eco mode is disabled.
– “Eco Mode” is not displayed in the
display menu (page 24).
Dialling mode
I
f you cannot make calls, change this setting
according to your telephone line service. The
default setting is “Tone”.
“Tone”: For tone dial service.
“Pulse”: For rotary/pulse dial service.
1 M
N#120
2 MbN:
Select the desired setting. a MOKN
a M
N
Low battery alert
T
his feature allows the unit to beep when the
battery needs charging.
When this feature is turned on, the unit notifies
you as follows.
n When the handset is in standby mode:
– If the battery needs charging, the unit
beeps at the selected interval up to 3
times.
Note for handset:
R At the end of each call, the unit displays a
large icon for a few moments to indicate the
battery level.
Setting low battery alert
T
o turn this feature on, select the desired alert
interval, or select “Off” to turn this feature off.
The default setting is “Every Hour”.
1 M
N#176
2 MbN:
Select the desired setting. a MOKN
a M
N
13
Getting Started
To Next Page
Loading...
