To switch back to the receiver, press MZN/
M
N.
R In step 1, you can store the dialed phone
number to the phonebook by pressing and
holding MFN W for a few seconds.
Making a call using the redial list
The last 5 phone numbers dialed are stored in
the redial list (48 digits max. each).
1 MEN REDIAL
2 MbN: Select the desired entry.
3 M
N
Pause (for PBX/long distance service
users)
A pause is sometimes required when making
calls using a PBX or long distance service.
When storing a calling card access number
and/or PIN in the phonebook, a pause is also
needed (page 43).
Example: If you need to dial the line access
number “9” when making outside calls with a
PBX:
1 9 a MDN (Pause)
2 Dial the phone number. a M N
Note:
R A 3.5 second pause is inserted each time
MDN (Pause) is pressed.
Answering calls
When a call is being received, the ringer
indicator flashes rapidly.
1 Lift the handset and then press M N or
MZN when the unit rings.
R To answer a cellular call, you can also
press MCELLN.
2 When you finish talking, press MOFFN or
place the handset on the base unit or
charger.
Any key answer: You can answer the call by
pressing any dial key.
Auto talk: You can answer calls simply by
lifting the handset (page 51).
Temporary handset ringer off: You can turn
the ringer off temporarily by pressing M N.
Adjusting the handset ringer volume
n While the handset is ringing for an
incoming call:
Press MjN or MkN repeatedly to select the
desired volume.
n While the handset is in standby mode:
Press MjN or MkN repeatedly to select the
desired volume for landline call.
R To turn the ringer off, press MkN repeatedly.
Note:
R You can adjust the ringer volume for
cellular call and landline call by
programming (page 47, 49).
R The ringer volume you set is kept for each
line (landline and cellular lines).
One-touch ringer off for the handset
Press and hold 0 ( ) until the unit beeps to
turn the ringer off. While the ringer is turned
off, the handset will not ring for calls.
R You can turn the ringer on again by:
– pressing and holding 0 (
) until the
unit beeps
– changing the volume using navigator key
MDN (Vol.)
– pressing MjN repeatedly
Useful features during a
call
Hold
1 Press MMENUN during an outside call.
2 MbN: “Hold” a MSELECTN
3 To release hold on the cellular line:
Press MCELLN.
*1
R Another handset user can take the call
by pressing MCELLN.
*1
*1 If you press MCELLN and the
selection list is displayed, select
the desired cellular line and press
MSELECTN.
For assistance, please visit http://shop.panasonic.com/support
25
Making/Answering Calls Using the Handset
To Next Page
Loading...
