Baby monitor sensitivity
Y
ou can adjust the sensitivity of the baby
monitor. Increase or decrease the sensitivity to
adjust the sound level needed to trigger the
baby monitor feature.
R This feature cannot be set during a
monitoring call.
Handset
1 P
ress MMENUN on the handset being
monitored.
2 MbN: “Sensitivity level” a
MSELECTN
3 MbN: Select the desired setting. a
MSAVEN a MOFFN
Answering the baby monitor
n W
hen monitoring with a unit:
Handset: Press M
N
to answer a call.
Base unit: Press M
N
to answer a call.
If you want to respond from the monitoring
unit, press MMUTEN.
R The monitoring unit will answer calls
automatically when the auto intercom
feature is set to “On” (page 19).
Note:
R If you receive an outside call when
communicating with the monitored handset,
the interrupt tone sounds.
– To answer the call with the handset,
press MOFFN, then press M
N.
–
To answer the call with the base unit,
press MZN 3 times.
*1
*1 If MMUTEN is pressed, press MZN 2
times.
n When monitoring from an outside line:
Answer the call.
If you want to respond from your monitoring
phone, press #1 using tone dialing.
You can turn off the baby monitor feature
by pressing #0.
Note:
R The unit disconnects the call automatically
after 2 minutes.
Other programming
Changing the handset name
T
he default handset name is “Handset 1” to
“Handset 6”. You can customize the name
of each handset (“Bob”, “Kitchen”, etc.). This is
useful when you make intercom calls between
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 38).
Handset
1 MM
ENUN#104
2 Enter the desired name (10 characters
max.).
3 MSAVEN a MOFFN
Displaying the handset name
Y
ou can select whether or not the handset
name is displayed in standby mode. The
default setting is “Off”.
Handset
1 MM
ENUN#105
2 MbN: Select the desired setting. a
MSAVEN a MOFFN
Registering a unit
Operating additional units
Additional handsets
U
p to 6 handsets can be registered to the
base unit.
Important:
R See page 4 for information on the available
model.
38
For assistance, please visit www.panasonic.com/support
Programming
To Next Page
Loading...
