2 MbN: “2 way recording” a MSELECTN
R The total recordable time is displayed.
R The unit announces to both parties that the
recording will start.
R The unit starts recording.
3 To stop recording, press MMENUN a MbN:
“Stop recording” a MSELECTN
R You can continue the conversation with the
outside caller.
Note:
R When recording completes:
– The total number of recordings will be added
to answering system number of messages.
– M N on the base unit flashes.
– “New message” is displayed.
– Audible message alert sounds on base unit.
R To listen to the recorded conversation, see
page 49, 49.
R 2 way recording is not available during
conference calls.
R The recording will end in below situations:
– MFLASHN is pressed.
– Hold or Intercom feature is used.
R When memory is/becomes full:
– “Memory full” is shown on the display.
– Error tone sounds.
Call share
You can join an existing outside call.
Handset
To join the conversation, press M N when the
other unit is on an outside call.
Base unit
To join the conversation, lift the corded handset
when the handset is on an outside call.
Note for handset and base unit:
R A maximum of 3 parties (including 1 outside
party) can join a conversation. (3-way
conference)
R To prevent other users from joining your
conversations with outside callers, turn call
sharing mode off (page 40).
Transferring calls, conference calls
Outside calls can be transferred or a conference
call with an outside party can be made:
– between 2 handsets
– between a handset and the base unit
Handset
1 During an outside call, press MMENUN.
2 MbN: “Intercom” a MSELECTN
3 MbN: Select the desired unit. a MSELECTN
R If you select “Voice paging”, the call will
be switched from the ear-receiver mode to
the speakerphone mode.
4 Wait for the paged party to answer.
R If the paged party does not answer, press
MBACKN to return to the outside call.
5 To complete the transfer:
Press MOFFN.
To establish a conference call:
MMENUN a MbN: “Conference” a
MSELECTN
R To leave the conference, press MOFFN. The
other 2 parties can continue the
conversation.
R To put the outside call on hold: MMENUN a
MbN: “Hold” a MSELECTN
To resume the conference: MMENUN a
MbN: “Conference” a MSELECTN
R To cancel the conference: MMENUN a MbN:
“Stop conference” a MSELECTN
You can continue the conversation with the
outside caller.
Base unit
1 During an outside call, press MINTERCOMN.
When 2 or more handsets are registered:
MbN: Select the desired unit. a MSELECTN
R To page all handsets, press 0 or wait for a
few seconds.
2 Wait for the paged party to answer.
R If paged party does not answer, press
MINTERCOMN to return to the outside call.
3 To complete the transfer:
Place the corded handset on the cradle.
R The outside call is being routed to the
handset.
To establish a conference call:
Press MCONFN.
R To leave the conference, place the corded
handset on the cradle. The other 2 parties
can continue the conversation.
R To put the outside call on hold, press
MHOLDN. To resume the conference, press
MCONFN.
20
For assistance, please visit http://shop.panasonic.com/support
Making/Answering Calls
To Next Page
Loading...
