Panasonic KX-TGF870C - Handset Battery Charging; Base Unit Battery Installation (for Power Backup)

Removing the battery
1
2
Handset battery charging
C
harge for about 7 hours.
R Confirm “Charging” is displayed (
1
).
R W
hen the batteries are fully charged, “Fully
charged” is displayed.
1
Handset battery level
Icon Battery level
High
Medium
Low
Needs charging.
Empty
Note:
R A
t the end of each call, the unit displays a large
icon for a few moments to indicate the battery
level.
R You can set the unit to beep when the battery
needs charging. (page 15)
Ni-MH battery performance (supplied batteries)
Operation Operating time
In continuous use
10 hours max.
*1
Not in use (standby)
5 days max.
*
1
*1 If eco mode is on.
N
ote:
R Actual battery performance depends on usage
and ambient environment.
Base unit battery installation (for
p
ower backup)
You can insert 2 AAA (R03) batteries (not
supplied) into the base unit that will power the unit
temporarily in the event of a power failure.
Important:
R The following batteries can be used with the
base unit:
– Rechargeable Ni-MH batteries
*1
,
*2
(including
the batteries used in your handset(s))
– Standard (non-rechargeable) alkaline
batteries
*3
R Do NOT use manganese batteries.
R Confirm correct polarities (
, ).
*
1 The base unit can fully charge Ni-MH batteries
in about 15 hours.
*2 We recommend using HHR-4DPA batteries
(page 4).
*3 Only insert alkaline batteries once a power
failure occurs. Remove the alkaline batteries
when power is restored.
1 Disconnect the telephone line cord (A).
2 Open the battery cover (B).
3 Install the batteries in the battery compartment
(C).
10
For assistance, visit www.panasonic.ca/english/support
Getting Started
TGF87xC_(en)_0204_ver031.pdf 10 2020/02/04 9:33:42