R T
o leave the conference, press MOFFN.
The other 2 parties can continue the
conversation.
R To put the outside call on hold:
MMENUN a MbN: “Hold” a
MSELECTN
To resume the conference: MMENUN
a MbN: “Conference” a MSELECTN
R To cancel the conference: MMENUN a
MbN: “Stop conference” a
MSELECTN
You can continue the conversation
with the outside caller.
Base unit
1 During an outside call, press
MINTERCOMN.
When 2 or more handsets are
registered:
– To page a specific handset, enter the
handset number.
– To page all handsets, press 0 or wait
for a few seconds.
2 Wait for the paged party to answer.
R If paged party does not answer, press
MINTERCOMN to return to the outside
call.
3 To complete the transfer:
Press MSP-PHONEN.
R The outside call is being routed to the
handset.
To establish a conference call:
Press MCONFN.
R To leave the conference, press
MSP-PHONEN. The other 2 parties can
continue the conversation.
R To put the outside call on hold, press
MHOLDN. To resume the conference,
press MCONFN.
Intercom
I
ntercom calls can be made:
– between handsets
– between a handset and the base unit
Note for handset and base unit:
R When paging unit(s), the paged unit(s)
beeps for 1 minute.
R I
f you receive an outside call while talking
on the intercom, the interrupt tone sounds.
– Handset: To finish intercom, press
MOFFN. To answer the call, press M
N.
– B
ase unit: To finish intercom, press
MSP-PHONEN. To answer the call, press
MSP-PHONEN again.
Note for handset:
R To change the handset ringer volume and
ringer tone for intercom, see page 39.
Making an intercom call
Handset
1 MMENUN a MbN: “Intercom” a
MSELECTN
2 MbN: Select the desired unit or “Voice
paging”. a MSELECTN
R If you select “Voice paging”, speak
into the microphone after the beep.
Your voice will be heard using the
speakers of the base unit and all
handsets, until a paged party answers
your page or until you press MOFFN.
After the other party answers, the
speakerphone mode is turned on.
3 When you finish talking, press MOFFN.
Note:
R You can also use the MINTERCOMN soft
key, if displayed, to make intercom calls.
R You cannot use voice paging if other units
are in use.
Base unit
1 P
ress MINTERCOMN.
When 2 or more handsets are
registered:
– To page a specific handset, enter the
handset number.
– To page all handsets, press 0 or wait
for a few seconds.
2 When you finish talking, press
MSP-PHONEN.
For assistance, please visit http://shop.panasonic.com/support
21
Making/Answering Calls
To Next Page
Loading...
