– pre-recorded greeting message
Recording a greeting message for
a
utomated call block
Using this feature, the unit can play your own
greeting message and pre-recorded greeting
message.
Example of your own greeting message:
“Hi, you have reached xxxxxxx (Name).”
“Thank you for your calling, You have reached
xxxxxxx (Name).”
“Hi, you have reached the xxxx (Name)
residence.”
1 MMENUN#791
2 MbN: “Yes” a MSELECTN
3 After a beep sounds, hold the handset
about 20 cm (8 inches) away and speak
clearly into the microphone (2 minutes
max.).
4 Press MSTOPN to stop recording.
5 The unit will play the recorded greeting
message for automated call block. a
MOFFN
Resetting to the pre-recorded
g
reeting message for automated call
block
This procedure will erase your greeting
message for automated call block and reset to
the pre-recorded one.
1 MMENUN#793
2 MYESN a MOFFN
Playing back the greeting message
f
or automated call block
1 MMENUN#792
2 To exit, press MOFFN.
Telemarketing call block
I
n addition to Automated call block (page 29),
you can use Telemarketing call block to
further screen calls to stop telemarketer calls
f
rom getting through.
Using this feature, you can ask callers to say
their names, and after checking the names,
you can decide whether to answer the calls or
not.
Note:
R While screening calls, the call waiting
feature is unavailable (page 19).
Operating telemarketing call
b
lock
Handset
1 D
uring an outside call, lift the handset
and then press MTELE.BLK.N.
R The unit prompts callers to say their
names.
2 To answer the call:
Press M
N
or MZN.
To block the call:
Press MCALL BLOCKN
*1
a MYESN.
R The unit announces that the call will be
disconnected, and disconnects the call.
R The caller will be registered to call
block list.
*1 The user can still answer the call after
pressing MCALL BLOCKN. To answer the
call, press M
N
or MZN.
Base unit
1 P
ress MTELE.BLK.N during an outside
call.
R The unit prompts callers to say their
names.
2 To answer the call:
Press MSP-PHONEN.
To block the call:
Press MCALL BLOCKN
*1
a MYESN.
R The unit announces that the call will be
disconnected, and disconnects the call.
R The caller will be registered to call
block list.
*1 The user can still answer the call after
pressing MCALL BLOCKN. To answer the
call, press MSP-PHONEN.
For assistance, please visit http://shop.panasonic.com/support
31
Enhanced Call Block
To Next Page
Loading...
