Call block
n
Pre-installed block list:
The unit can block calls when receiving the
call from the phone number in
pre-programmed call block list (14,000 items).
Database is supplied by YouMail Inc..
n Manual call block:
You can press the MCALL BLOCKN button in
the following situations to disconnect the
current call and add a phone number to the
call block list:
– when an incoming call is being received
– when an incoming call is being recorded by
the answering system
– when talking on an outside call
Once a phone number has been added to the
call block list, the unit will block calls from that
phone number in the future.
Handset / Base unit
1 P
ress MCALL BLOCKN under the
situations shown above.
2 Confirm the call block number and press
MYESN.
R The call block number is stored in the
call block list, confirmation tone
sounds
*1
and “Call blocked” is
displayed, and then the call is
disconnected.
*1 Confirmation tones are used with
permission of © 2018 Copyrights Vision
Inc.
Note:
R If the call has no phone number, the call is
blocked but it is not stored in the call block
list.
R The call block feature is not available:
– for intercom calls or calls received by call
waiting.
– when a landline call (or cellular call) is
being received during a cellular call (or
landline call).
R Blocked calls are logged in the caller list.
Storing unwanted callers
T
he unit can block calls by storing the desired
items in the call block list beforehand (Caller
ID subscribers only).
– “Single number”
*1
/“Single #”
*2
: The
unit blocks calls from specific phone
numbers stored in the call block list.
– “Range of numbers”
*1
/“Range of
#”
*2
: The unit blocks calls that begin with a
number stored in the call block list, such as
a toll-free phone number prefix or certain
area codes.
– “Block unknown CID”
*1
/“Block
unknown”
*2
: The unit blocks calls that
have no phone number.
*1 Handset
*2 Base unit
Single phone numbers and ranges of numbers
can be stored in the call block list up to 2,000
items in total.
Blocking unwanted callers:
When a call is received, the unit will not ring
while caller information is being received.
*1
If the caller’s phone number matches an entry
in the call block list, the unit emits no sound to
the caller, and disconnects the call.
*1 If you want the first ring to sound, select
“Yes” in “Turning the first ring on/off”
(page 40).
Storing a single phone number
I
mportant:
R We recommend storing 10 digits (including
the area code). If only 7 digits are stored, all
numbers that have the same last 7 digits
will be blocked.
Adding call blocked numbers from
t
he caller list
Handset
n W
hen a cellular phone is paired:
1 MCN CID
38
For assistance, please visit http://shop.panasonic.com/support
Call Block
To Next Page
Loading...
